Are you looking for a specialist to clean out your ? Do you want to make sure that your fireplace is taken care of? Are you finding
how to build wood burning fireplaces it difficult to get a great performance out of your fireplace? Whatever your needs may be, we have a solution. We are the fireplace service specialist near Phoenix. Contact our specialists today to get started.
I wanted to experiment with getting more of an authentic plaster look, though, so I opted to skim-coat the entire wall with joint compound. I just used the pre-mixed all-purpose stuff, and I wasn’t too careful about it: I wanted the thickness of the skim-coat to vary slightly along the surface of the wall. In some places it’s barely there at all, and in some places it’s probably about 1/8″ thick.
Here’s a terrible picture of the whole wall skim-coated. The whiter spots are where the joint compound is thinner and dried faster. It doesn’t look at all like a textured wall or anything—it’s just very very subtly uneven so that it doesn’t stand out as looking flat and new. I sanded it all before painting and it really is indistinguishable from the plaster. Yay!
Wrong! I took myself to a local stone place (that mainly does countertops and stuff) and found this really gorgeous slab. It was honed, it was about the right size, and it was even a little damaged along the edges and had a couple scratches, which I sort of liked. But then it priced out at over a thousand dollars, so I burst into tears and ran away. Soapstone was even more expensive, and granite was a little cheaper but still too much money, and I didn’t want granite at all anyway.
Then it dawned on me: what about good old Kingston bluestone? I suppose it’s even possible that that’s what was here originally, but who knows. I could probably find something that was locally quarried, super pretty, and much cheaper than marble or soapstone. It would reference Kingston history and even sort of tie into the exterior of the house, which is lined with bluestone sidewalks and pathways.